Business

B15 – NEUCEPLAD – Plastic Paint for Plasterboard
CONSIDERATIONS:

Based on a styrene emulsion – acrylic in aqueous dispersion, pigmented with titanium dioxide and inert loads, this paint has been specially studied for interior paintings over drywall surfaces.
Allows you to economize work force, because it exonerates the application of a primer.

PROPERTIES:

-

CHARACTERÍSTICS: -

Very good opacity.
Good coverage.
Good whiteness and finish.
Good income.
Easy application and good adhesion.
Density.......................................1,606 ± 0,10
Viscosity.....................................98 -132 Ku (25ºC)
Color...........................................White
Finish..........................................Mate
Drying to touch..........................± 30 minutes
Drying between coats …….…. 2 – 4 hours
In dry conditions, ± 20ºC and ventilated

-

Inflammation Point …………. Not flammable
Solid Content ……………….. 65 ± 2
COV (volatile organic composites) …. ª) Limit value UE for this product cat. (A/a) 30 g/l (2010). This product contains 6 g/l
COV maximum.

USE:

It is intended primarily to the painting of interior surfaces on gypsum board (drywall), projected stucco, etc, without the need to apply any kind of primer, allowing the disguise of amendments in the area of the plate’s joints, presenting a matte finish with good coverage and adhesion.

SURFACE
PREPARATION:

On new surfaces, this should be dry, clean, firm, and free from dust, grease and other contaminants before starting the application.
In the particular case of gypsum board must be held a general sanding of the masses, with special attention in the joint areas and plates fixation, proceed to the aspiration of the entire surface, in order to release the dust from the substrate.
In case of repainting brush the walls very well in order to be eliminated remains of old paint or to exfoliate, a preliminary sanding, with a fine grit sandpaper is convenient