Normas para verif de paquimetros
3292 palavras
14 páginas
UDC 389 :531.714.8 :681.2 :620.1DEUTSCHE N ORM
December 1988
Vernier callipers
DIN
Requirements and testing
862
MeBschieber; Anforderungen, Prufung
Supersedes March 1979 edition.
In keeping with current practice in standards published by the International Organization forStandardization (ISO), a comma hás been used throughout as the decimal marker.
See Explanatory notes for connection with International Standards ISO 3599-1976 and ISO 6906-1984 published by the International Organization for Standardization (ISO).
Dimensions in mm
1 Reld of application m >
This Standard applies both to analogue vernier callipers with a maximum measuring range f rom O to 2000 mm and a vernier or circular scale graduated in 0,1,0,05 or 0,02 mm, and to vernier callipers with digitized output over ranges from O up to a maximum of 1000 mm in 0,01 mm incrementa.
2 Terminology
See DIN 2257 Parts 1 and 2 for concepts relating to dimensional metrology, and DIN 1319 Parts 1 to 4 for basic metrological concepts. 3
i!
_o
ou c o> o .a
Designations and dimensions
Vernier callipers are not expected to conform to the designs illustrated here; compliance is only required in the case of the dimensions specified.
For general tolerances, accuracy grade m as specified in DIN 7168 shall apply.
3.1 Vemier callipers designed for internai, externai and depth measurement
o.-z: oO Type 1A, with clamping screw
Type 2A, with clamping device
The above types are normally designed for measuring lengths up to 160 mm.
is =
'í í
Knife-edge faces for measuring internai dimensions of 3 mm or more
5.5
'C 03
oE
Clamping screw
Slider
Depth-measuring blade
Beam
3
10
11
12
13
14
15
16
17
llllllllllllllll milllll lllllmilimilimiiulmillllllllll l llllllll ll|lllllllllllillllllllll
Vernier with vernier scale
Fixed jaw
~7~
Main scale
Measuring faces for depth measurement Clamping device
Faces for externai measurement
Dimensions as specified in table 1; indication as per clause 4.