Manual s7 200 siemens

Preface, Contents Introducing the S7-200 Micro PLC Installing an S7-200 Micro PLC Installing and Using the STEP 7-Micro/WIN Software Getting Started with a Sample Program Additional Features of STEP 7-Micro/WIN Basic Concepts for Programming an S7-200 CPU CPU Memory: Data Types and Addressing Modes Input/Output Control Network Communications and the S7-200 CPU Instruction Set Appendix S7-200 Data Sheets Power Calculation Table Error Codes Special Memory (SM) Bits How STEP 7-Micro/WIN Works with Other STEP 7 Programming Products Execution Times for STL Instructions S7-200 Order Numbers S7-200 Troubleshooting Guide Index

1 2 3 4 5 6 7 8 9 10

SIMATIC S7-200 Programmable Controller
System Manual

This manual has the order number: 6ES7298-8FA01-8BH0

A B C D E F G H

Safety Guidelines

This manual contains notices which you should observe to ensure your own personal safety, as well as to protect the product and connected equipment. These notices are highlighted in the manual by a warning triangle and are marked as follows according to the level of danger: Danger indicates that death, severe personal injury or substantial property damage will result if proper precautions are not taken.

!

!

Warning indicates that death, severe personal injury or substantial property damage can result if proper precautions are not taken.

!
Qualified Personnel

Caution indicates that minor personal injury or property damage can result if proper precautions are not taken.

The device/system may only be set up and operated in conjunction with this manual. Only qualified personnel should be allowed to install and work on this equipment. Qualified persons are defined as persons who are authorized to commission, to ground, and to tag circuits, equipment, and systems in accordance with established safety practices and standards.

Correct Usage

Note the following:

!

Warning This device and its components may only be used for the applications described in